EN
13
Wireless flush-mount ON / OFF actuator 868.3 MHz
Wireless flush-mount ON / OFF actuator 868.3 MHz
Unpair
Press and hold the pair button for 3 seconds.
The LED will flash red.
Whilst the LED is flashing,
press the respective button on
the right of the BrematicPRO
wireless remote control you
wish to unpair.
This completes the unpairing
process.
Pairing the Wireless flush-mount ON / OFF
actuator with the BrematicPRO Gateway
When linked with the Home Automation Systems BrematicPRO via
the BrematicPRO Gateway, you can use the app / BrematicPRO PC
software to use additional software-based functions, e.g. timer control,
theme control, astro function (dawn/dusk control).
The app or BrematicPRO PC software is installed and open.
The BrematicPRO Gateway is ready for use.
Keep the device at least 50 cm from the Gateway.
Open the “Settings“ menu.
Select the room where you wish to use the device.
Select the frequency “868 MHz“.
Select “Add Device“.
Under “New Device“, select “Switch / Socket“ and click “Continue“
to confirm your selection.
Follow the on-screen instructions.
Press and hold the pair button on the device for 3 seconds.
Enter a device name, e.g. “Living Room Lamp“.
Select “Add“ to assign the device to the room.
First tap “Back“ to leave the room, then “Done“ to complete the
pairing process.
The wireless flush-mount ON / OFF actuator is now connected
to the Home Automation Systems BrematicPRO.
Use “Test Device“ to switch the consumer on and off to ensure
the wireless on/off actuator is working properly.
In this submenu you can also add the wireless flush-mount
ON / OFF actuator to your favourites.
For more information about the app and how to use it, please visit:
www.brematic.com/en/service.
Factory Reset
The device can be restored to the factory settings at any time. A reset
will be required if malfunctions occur.
Press the pair button for at least 6 seconds.
The LED will flash rapidly and go out after approx. 3 seconds.
The device has been reset.
Cleaning the Device
DANGER! RISK OF ELECTRIC SHOCK!
Disconnect the device from the mains before cleaning.
Do not allow liquids to enter the device. Liquids entering can result in
a short circuit.
Clean the device with a dry, lint-free cloth. For tough dirt, you
may also slightly dampen the cloth.
Do not clean with solvent-based cleaners. These could damage
the device surface and markings.
Never immerse the device in water or other liquids. The product
may otherwise be damaged.
Ensure the device is completely dry before using it again.
