4-10
Initial Set-up
To ensure the spring tab fully engages in
the tube cartridge, turn the spool COUN-
TERCLOCKWISE about one inch and push.
To fasten the spool to the cartridge tube,
slide the PVC spacer until holes align,
then temporarily secure with bolt and nut.
See Fig. 9.
Front Spool (Red)
2. Install the front spool and related com-
ponents in the same manner as the
rear. Then turn CLOCKWISE and push
on. Drill out hole on pipe to 3/8" dia.
hole. Slide the PVC spacer on and
secure with roll pin. See Fig. 9.
251915-9
Fig. 9
• Attaching Spools To Roll Tube
Rear Spool (Black)
The inside of the spools are pre-greased
for use and color coded for assembly.
1. Slide the rubber ring on the roll tube
about 2 inches. Then insert the black
end of the spring into the black spool
so the spring tab extends through
the small hole in the spool. Slide the
spring with spool over the black end
of the roll tube so that the cartridge
tube extends through the center hole
of the spool. Drill out hole on pipe to
3/8" dia. hole as shown in Fig. 9.
Roll Tarp Assembly
3. Hand roll the tarp into open position.
Place the 1" stationary tube side of the
tarp on top of the left side of the box,
centered from front to back of box. BE
CAREFUL NOT TO LET THE TARP
ROLL OFF OF THE BOX. Assemble the
tarp and stops (26) (with caps) to the
left side boards with fl ange screws and
fl ange nuts. Attach 12" from each end.
4. Attach 2 stops (front & rear) aligned
with the groove on the endcap. Attach
the remaining stops to the middle bows
on the left side of the cart. Holes need
251915-10
Fig. 10
to be predrilled into sideboards and tarp.
Tighten bows on the left side fi rst and
fi nish by tightening the right side.
Revised 061107-12
Summary of Contents for Corner Auger 1080
