4-15
Initial Set-up
Fig. 5
5. Position the bows (10) under the right
side brackets (9) and retain (fi nger tight)
with 3/8 x 1 carriage bolts (18) and
fl ange nuts (16). See fi gure 5.
• Ridge Strap, Tarp, Tubes
1.
Attach the hooks on each end of the two
ridge strap assemblies to the holes in the
center of the end caps. Run the straps
over the top of the bows (10). Draw the
straps snug tight with ratchets.
Do not
overtighten
. See fi gure 6.
Fig. 6
7.
(2-person operation)
On a clean fl oor,
lay the tarp out fl at with the raw edge
of the hems and pockets down and the
exterior side facing up.
8.
Insert the small 1 1/8" tube (6) by sliding it
into the small pocket of the tarp. Leave 1"
of the tube sticking out one end and drill a
3/16" hole through the center of the outer
reinforcement strap and tube. Fasten with
a rivet (8). At the other end, pull on the
tarp by hand to stretch it until there is 1"
of tube sticking out. Drill hole and install
rivet. Press the 1 1/8" plugs (41) into each
end of the tube. See fi gure 7.
INSTALLATION TIP:
Tarp is designed to be stretched the length of
the tube to reduce wrinkling. For easier as-
sembly apply liberal dusting of baby powder on
tube and inside of tube pockets before sliding
tubes in pockets.
Insert the 2" roll tube into the large
pocket, with the splined shaft to the rear.
Measure 10 1/2" from the end of the
spline to the start of the tarp. Install the
fi rst U-clamp (37) and self-drilling screws
(45) to the fi rst reinforcement strap, to
secure the tarp to the tube. Work down
the roll tube putting the U-clamps and
self-drilling screws on each reinforcement
strap. Make sure to keep the tarp pulled
tight to reduce wrinkling. See fi gure 7.
Model 880 ONLY, mount tarp defl ectors
approximately 6” in from ends (see parts
pages for additional information). Grain
carts with any unused holes on the side
of the cart need to be plugged.
Fig. 7
Revised 081408-16
Summary of Contents for Corner Auger 1080
