7
9.
Return Frying Basket back to Fryer if you will continue Frying. If
more batches of frying will be done, close the lid and allow the oil
to rise back to the desired temperature.
Cleaning Your Deep Fryer:
WARNING:
Always turn the appliance to “Off” and unplug the product,
allow it to cool before cleaning or storing it.
NOTICE
: Always disconnect appliance from the outlet and then remove the
Magnetic Plug from the unit. The plug should always remain on during
operation. If it becomes disconnected, immediately unplug the cord from
the wall outlet then reconnect the magnetic cord to the socket.
1.
Once all parts have cooled, remove the Frying Basket from the Oil
Reservoir and wash the Frying Basket in hot soapy water. Rinse and
towel dry carefully.
2.
Oil can be reused by storing it. After oil has cooled (approx. 2 hours)
remove the Lid by pulling firmly upwards, empty the oil into a
container and filter it through a fine strainer to catch all the bits of
food that may have been left behind.
3.
Once the oil has been stored or discarded. You can clean the interior
of the Fryer by first wiping the inside with paper towels to absorb
any excess oil. Add a small amount of hot soapy water gentry scrub
the inside using a nonabrasive sponge.
IMPORTANT:
Never submerge the base or clean under running
water. Add water into the unit using a small cup and empty very
carefully.
4.
Discard the water in the sink and dry the Fryer completely.
NOTE
: A removable condensation trap is located on the back of the
Fryer. The Condensation Trap will collect any water that has
condensed in the inside of the Lid and when the Lid is opened after
frying. Clean Condensation Trap after each use by simply rinsing
with warm water. Dry and return to its place.
5.
Clean the exterior of the Fryer and Lid with a damp cloth and dry.
DO NOT USE ANY TYPE OF STEEL WOOL PADS TO CLEAN MAGNETIC
CONTACTS.
6.
To replace or clean filters, open the filter cover, the foam grease
filter may be washed with hot soapy water and air dried. Clean the
inside cover with sponge and dry thoroughly. Insert charcoal odor
filter first followed by the grease filter and replace filter cover.
NOTE: Ensure Lid is always in its secure place prior to operation of
unit.
