7
3
installation instructions
Please check before installing the product to ensure that the product can
work normally.
This document provides wall mounted installation methods for reference,
and other installation instructions can be obtained by contacting our
personnel;
3.1 gate type installation
chart 3
-
1
Step 1: as shown in Figure 3
-
1, if there is no hole on the gate panel, it is
necessary to use a punch to make a circle with a diameter of 35mm on the
gate panel;
Step 2: as shown in Figure 3
-
2, thread the external wiring of the identification
terminal and the vertical pole support through the hole on the gate panel;
Step 3: as shown in Figure 3
-
3, thread and tighten the upright nut from below
to fix the identification terminal;
Chart3-2
chart 3-3
