9 | Imprint
16 / 21
IM_4670350_de_en_BRESSER_v1016
6
Eyepiece holder
7
Focussing wheel
8
Mounting connection
9
Level
10
Tripod head plate
11
Locking lever (Tripod head plate)
12
Fixing screw (Tripod head inclination 90°)
13
Fixing screw (Horizontal movement)
14
Handle and fixation (vertical movement)
15
Crank handle (Height adjustment)
16
Locking ring (Height adjustment)
17
Circular level
18
Transport handle
19
Locking ring (Tripod bridge)
20
Tripod bridge (Strut)
21
Clamping lever (Tripod leg)
22
Hook for accessories
23
Rupper foot
Accessories:
24
Eyepiece
25
Amici prism
26
Viewfinder with bracket
9 Site location
Choose a dark location to avoid an interference of dark adaption throughout lights. A flat and stable
surface is recommended.
Do not observe from closed rooms. Approx. 30 minutes before starting an observation, position the
telescope and the accessories on the desired location to allow a temperature compensation.
10 Setting up the tripod
1. Loosen the locking ring for the tripod bridge.
2. Pull out the tripod legs slowly until the tripod bridge is opend completely.
3. Tighten the locking ring for the tripod bridge by hand.
4. Open the clamping lever for the tripod legs.
5. Pull out the tripod legs to the desired height. Make sure that the bubble of the circular level is in
the middle of the circle to ensure a horizontal plane stand.
6. Close the clamping lever for the tripod legs.
7. Loosen the locking ring for the height adjustment.
8. Pull out the tripod head to the desired height by using the crank handle.
9. Tighten the locking ring for the height adjustment by hand.
