Bresser 9621502, Operating Instructions Manual

9

EN

Parts



  Eyepiece with TwistUp eyecups



  Zoom adjustment (zoom wheel)



  Fine adjustment (focus wheel)



  Optical Tube 



  Sun shield



  Tripod adapter thread



  Main tube clamp



  Fastening screw

Setting up the spotting scope

Ideally the spotting scope should be on a tripod of suitable loadbearing capacity 

(Tripod included). Your spotting scope has a tripod thread to DIN standard (6). It 

can therefore be attached to any tripod with a DIN standard thread.

WARNING 
Never look directly at, or near to the sun with this device. 
There is a RISK OF BLINDNESS!

IMPORTANT:

Remove the protective caps from the tube and eyepiece. Be sure to replace the 

protective caps on the lenses each time after using the spotting scope.

Operation

• 

Focus wheel: 

 Look into the eyepiece (1) and turn the focus wheel (3) in either 

direction to focus on an object.

• 

Zoom: 

Rotate the zoom wheel (2) to zoom in or out of an object. Then use the 

focus wheel (3) to focus.

•  Moving the main tube:

 The spotting scope has a main tube clamp (7) and 

fastening screw (8). Turn the screw (8) counter-clockwise to undo the main tube 

clamp. You can then turn the entire main tube (4) about its own axis and thus 

vary the eyepiece (1) position. To fasten the main tube in the desired position 

turn the fastening screw clockwise.

• 

Indoor use and outdoor use:

 Even if you should occasionally observe objects 

through an open or closed window, the best results are still achieved outside. 

Temperature differences between the indoor and outdoor air as well as the 

low quality of window glass can cause images through the spotting scope to 

become blurred.

• 

Sun shield:

 You can extend the sun shield (5) in poor visibility conditions 

caused by strong sunshine, by simply sliding it.