Bresser 9633110, Instruction Manual

19 / 28

8 Delivery content

Game camera (A), mounting strap (B), 4x AA batteries (C), 1x 32 GB Micro SD card (D)

9 Setting up power supply

1. To insert the batteries, open the back cover by pressing and lifting the latch.

2. Insert the batteries into the battery compartment. Make sure that the battery polarity (+/-) is cor-

rect.

3. Close and secure the battery compartment. Make sure that the cover is firmly closed.

Note: please use only Alkaline batteries.

10 Insert micro SD memory card

1. Since the camera has no built-in memory, it can only work if a Micro SD card is inserted.

2. Please do not insert or remove an SD card when the power is on.

3. The device supports Micro SD cards with capacity up to 32 GB.

4. To insert a Micro SD card, push the card into the slot until you hear a click. The side with the letter-

ing must be facing up.

5. Insert the Micro SD card as indicated. Never force the card into the slot. Never bend or twist the

Micro SD card.

6. To remove the Micro SD card, push the card slightly to pop it out.

7. It is recommended to format the card via the camera the first time it is used with the device.

8. To avoid malfunctions, keep the Micro SD card away from moisture and avoid vibration, dust, heat

sources and direct sunlight.

9. After transport, wait until the Micro SD card has reached room temperature before using it for the

first time. Major fluctuations in temperature or humidity may cause condensation and electrical
short-circuit. Store the micro SD card in a protective case when not in use.

10. When the Micro SD card is full, it will automatically stop taking pictures and videos.

11 Location / Assembly

1. Use the mounting strap to attach the camera to a tree, for example.

2. Before monitoring, please set all desired functions and parameters in the setting mode or use the

default mode.

3. The location should be chosen according to the objects to be observed. The recommended height

is 1-2 meters.

4. Please make sure that the camera points to the target area. The maximum distance of the IR lights

is 15 meters. Avoid direct backlight. Therefore, choose the position of the camera so that you can
point the camera towards the north or that the camera is in the shade.

5. Avoid high temperatures or strong movements in front of the camera. e.g. air conditioners, chim-

neys or other heat sources. This can have a negative influence on the shutter release behaviour of
the camera.

12 Initial operation

1. Press the ON/OFF button for about 3 seconds to turn the camera on.

2. Once powered on, the LCD will start counting from 10 to 1, and if no other buttons are pressed,

the camera will enter default mode.