11 / 36
The signal symbol flashes until the reception is successful. If no signal is received within 5 minutes,
the symbol disappears.
10 Automatic time setting
NOTICE! The reception of the radio signal for automatic time and date setting is done via the
outdoor sensor. Therefore, the connection between the outdoor sensor and the base station
must first be established.
The current time and date are automatically received and shown on the display of base station after
proper synchronization of the outdoor sensor and base station. This process may take a few minutes.
Note:
• The outdoor sensor searches for the time signal at 2:00 and 17:00 every day to update the time
and date information.
• Do not place the outdoor sensor and base station near sources of interference such as TVs, com-
puters, etc.
• Do not place the components near metal plates
• The use in enclosed spaces such as airport buildings, high-rise buildings or factories is not recom-
mended.
• Reception can be significantly disturbed in vehicles due to constant movement.
If the automatic reception of the radio signal does not work, perform a re-synchronization of the base
station with the outdoor sensor to re-initiate the reception of the radio signal. Please also read the
chapter "Finding and connecting a sensor" for more detailed information. If necessary, find a new loca-
tion for the individual components. When doing so, observe the above notes on reception.
If the reception of the radio signal fails even after several attempts of synchronization, the time and
date must be set manually. To do this, follow the instructions in the corresponding chapter.
11 Manual time setting
1. Press and hold TIME SET button for approx. 3 seconds to change to time setting mode.
2. Digits to be set are flashing.
3. Press +/CHANNEL or -/MEM button to change the value.
4. Press TIME SET button to confirm and continue to the next setting.
5. Settings order: 12/24 hour mode > Hours > Minutes > Seconds > Year > Change day and month >
Month > Day > Time zone > Language > Time signal reception ON/OFF > Daylight saving time
(DST) AUTO/OFF
NOTICE! Automatic setting of the dylight saving time (DST) is only available when time signal is
received.
6. Finally press the TIME SET button to save the settings and exit the setting mode.
12 Alarm setting
1. Press and hold ALARM button for approx. 3 seconds to enter the alarm time setting mode.
2. Digits to be set are flashing.
3. Press +/CHANNEL or -/MEM button to change the value.
4. Press ALARM button to confirm and continue to the next setting.
5. Settings order: Hours > Minutes
6. Finally press the ALARM button to save the settings and exit the setting mode. Alarm will be activ-
ated automatically. The symbol will be displayed.
7. Press ALARM button in normal display mode to display the alarm time.
