Imprint | 6
QS_7007310000000_de_en_BRESSER_v1116
13 / 15
6 Before starting operation
NOTICE
Avoid connectivity disruptions!
To avoid connectivity disruptions between the devices, consider the following points before starting
operation.
1. Place base station (receiver) and remote sensor (sender) together as close as possible.
2. Set up power supply for the base station and wait approx. 5 seconds.
3. Set up power supply for the remote sensor.
4. Position the base station and the remote sensor within the effective transmission range.
When changing batteries always change batteries in the main unit as well as all remote units and re-
place them in the correct order, so the remote connection can be re-established. If either of the
devices is mains-powered, the power supply must be disconnected for a short moment also for this
device when exchanging the batteries. If batteries are exchanged in only one of the devices (i.e. the
remote sensor) the signal can’t be received or can’t be received correctly.
Note, that the effective range is vastly affected by building materials and position of the main and re-
mote units. Due to external influences (various RC devices and other sources of interference), the
maximum distance can be greatly reduced. In such cases we suggest to position the main unit and the
remote sensor at other places. Sometimes all it takes is a relocation of one of these components of a
few inches! Though the remote unit is weather proof, it should be placed away from direct sunlight,
rain or snow.
7 Setting up power supply
Base station
1. Put the DC connector into the connection socket of the base station.
2. Put the mains plug into the power outlet.
3. The device is energized directly.
Remote sensor
1. Remove the battery compartment cover.
2. Insert the batteries into the battery compartment. Ensure that the battery polarity (+/-) is correct.
3. Replace the battery compartment cover.
8 Automatic time setting
After the batteries are installed. The clock will automatically search for the radio signal. It takes about
3-8 minutes to finish this process.
If the radio signal is received correctly, the date and time will be set automatically and the radio control
signal icon turns on.
If the clock fails to receive the time signal, go ahead with the following steps:
1. Press and hold the UP button for 2 seconds to re-initialize RC signal receiving.
2. 2. If the time signal receiving fails again, the time must be set manually.
Read the detailed manual for more information about manual time and alarm setting (see download in-
formation on page 2).
9 Receiving measurements automatically
Once batteries are installed, the base station will display the indoor temperature readings. Readings
from the remote sensor will be displayed within 3 minutes after powering it on.
Summary of Contents for MeteoTrend Colour
Page 15: ......
