Bretford TPM8PLATE Assembly Instructions Download

Page: 3 / 4

Drill four 5/32" diameter holes, at

least 2" deep. Fully insert eye lag

screws.

1. Drill four 1/4" diameter holes 1 3/8"

deep. Use ANSI B94.12-1977 carbide bit.

2. Tap anchors into hole to an embedded

depth of at least 1".

3. Use a hammer with a claw, pull anchor

out 1/4" to activate anchor.

Loop the tie wire over the ceiling truss and twist it

around itself at least four times. No additional

anchor is required.

STEP 4

Anchor the tray assembly to the ceiling using the correct anchoring method listed below.

NOTE:

Position anchoring holes so that the tie wire, when attached and taut, will angle outward at 15°.

(EE)

(FF)

Summary of Contents for TPM8PLATE

Page 1: ...oncrete Anchors 1 4 x 1 3 4 tie wire GG 4 030 0984 10 24 x 5 8 Self Tapping Screws HH 1 030 0990 12ga Galv Soft 20 Safety Wire II 2 030 0988 Safety Wire Clamps HARDWARE LIST WARNING A QUALIFIED PROFES...

Page 2: ...ified electrician NOTE For clarity only the ceiling track is shown CEILING TRACK CEILING TRACK STEP 3 Cut the 20 ft tie wire CC into four equal pieces Insert the wires through the ends of the turnbuck...

Page 3: ...at least 1 3 Use a hammer with a claw pull anchor out 1 4 to activate anchor Loop the tie wire over the ceiling truss and twist it around itself at least four times No additional anchor is required S...

Page 4: ...52 FAX 01753 53 94 78 800 343 1779 www bretford com WARNING IT IS THE RESPONSIBILITY OF THE INSTALLER TO SELECT THE CORRECT CEILING ANCHOR TO SUPPORT THE SAFETY CABLE AND THE COMBINED LOAD OF ALL ATTA...