42
MekFarmer 170
•
Pull the hoisting straps.
•
Loosen the screws fixing the clamps (1, “Fig. 9”) to the
roller.
•
Impede the rotation of the scraper holder bar (1).
•
Place the roller on the ground with the support plates (2,
“Fig. 10”) set in the assembly direction.
3
2
FIG. 10
•
Loosen the bolts (6, “Fig. 11”). Remove the spacer (7).
Remove the split pin and the upper pin (5). Lower the
arm (4) until it rests onto the lower pin (5). Insert the
upper pin (5) into the first free hole on the arm. Tighten
pins with the split pin.
4
5
7
6
FIG. 11
•
Fit the roller unit. Loosen the screws (8, “Fig. 12”) of the
roller supports to the arm (4).
8
4
FIG. 12
4.2.1 FITTING PTO GUARDS
•
Fitting rear PTO guards.
•
Put the guard into place (1, “Fig. 13”). Loosen the screws
(2). Fit the cap (3).
1
2
3
FIG. 13
•
Fit the PTO guard tractor side.
•
Put the guard into place (1, “Fig. 14”). Loosen the screws
(2). Loosen the bolt (3).
3
2
1
FIG. 14
4.2.2 FITTING OPTIONAL ROLLERS (OPT)
To fit optional rollers proceed as described in paragraph
.
