Breville EM6, Instructions For Use Manual

ATTACHING THE BEATERS/
DOUGH HOOKS

1. Place the Wizz Mix Plus stand on a level,

dry surface, such as a bench top. Ensure

the mixer stand arm is in the horizontal

position.

2. Attach the beaters to the mixer before it

is placed onto the mixer stand.

3. Insert each beater shaft into the left and

right beater sockets underneath the

mixer body (see Figure 1). Ensure the

beater with the white cog wheel collar is

inserted into the socket with the cog

wheel pattern. This is important to drive

the bowl.

4. Insert the beaters by pushing the shaft

into the socket, turning slightly if required

until they lock into place.

ATTACHING MIXER MOTOR 
TO MIXER STAND 

1. To attach the mixer body to the mixer

stand,  position the mixer motor on the

stand so that the back of the mixer aligns

with the back of the arm stand.

2. Press the mixer unit down on the stand

until the latch clicks into the locking

position. (see Figure 2).

6

4. Ensure that the speed selector switch is

set to the 'OFF' (O) position. Also ensure

that the mixer is securely attached to the

stand before using.

5. Add ingredients to the mixing bowl as per

the recipe or your requirements.

6. Position the mixing bowl platform

supplied on the mixer stand (See figure 3).

7. Place the glass mixing bowl on the mixer

stand (See figure 4).

8. Press the Tilt button while holding the

mixer body and lower the mixer assembly

so the beaters are inside the mixing bowl.

9.  Plug the cord into a 230/240v power

outlet and turn power 'ON'.

10. Place the beaters into the ingredients

inside the mixing bowl. To commence

mixing, move the speed selector switch

to the right to the required speed.

Always begin mixing on a lower speed

setting to prevent splattering, increasing

to the desired speed for the mixing task.

The speed setting can be adjusted during

operation by moving the switch from left

to right.

11. When mixing is complete move the speed

selector switch back the 'OFF' (O)

position. Turn the power off at the power

outlet and unplug cord.

12. Press the Mixer Pivot button and raise

the mixer unit to the upright position.

13. Remove the mixer from the stand by

pressing the Mixer Release button.

14. Remove the beaters/dough hooks by

pressing the eject button while grasping

the beater shafts. The beater/dough hooks

will be released automatically. DO NOT try

to pull the beaters/dough hooks out of the

sockets. Use a spatula to scrape remaining

mixture from the beaters/dough hooks.

ASSEMBLY AND OPERATION cont’d

7

ASSEMBLY AND OPERATION OF YOUR BREVILLE WIZZ MIX

The beater/dough hook

with the white cog wheel

collar should be in the

correct socket so that it

aligns with the cog wheel

gear on the mixer stand. 

If not placed correctly, the

bowl will not turn.

Always turn the Wizz Mix off

if you need to scrape down

the bowl during use. Then

continue mixing.

Make sure the mixer is

securely attached to the stand

and locked into the horizontal

position before using.

THE BEATERS/DOUGH HOOKS MUST BE INSERTED INTO THE CORRECT

SOCKET, AS THEY ARE NOT INTERCHANGEABLE . IF NOT PLACED

CORRECTLY, THE  BOWL WILL NOT TURN.

ENSURE THE MIXER IS SWITCHED OFF AND UNPLUGGED FROM THE

POWER OUTLET BEFORE ATTACHING THE BEATERS TO THE MIXER

AVOID CONTACT WITH BEATERS DURING OPERATION. KEEP HANDS,

HAIR, CLOTHING, SPATULAS AND OTHER UTENSILS AWAY FROM THE

BEATERS TO PREVENT INJURY OR DAMAGE TO THE WIZZ MIX.

Fig. 1

Fig. 2

Fig. 3

Fig. 4

BR3936 EM6 WizzMix Plus Book  22/7/02  4:29 PM  Page 6