Breville the Quick Stack LPC140SIL, Instruction Book

10

Care & Cleaning

Before cleaning, ensure the power is switched 

off and then remove the power plug from the 

power outlet.
Allow your pancake maker to cool before 

cleaning however, the pancake maker is easier 

to clean when still slightly warm.
Always clean your pancake maker after each 

use to prevent a build-up of baked-on foods. 

Wipe cooking plates with a soft, damp cloth to 

remove food residue.

WARNING

Do not immerse any part of the Breville 

Pancake maker or the power cord in water or 
any other liquid. 

PFOA-FREE NON-STICK COATING

Cooking on a non-stick surface minimises the 

need for oil as food does not stick and cleaning 

is easier. Any discolouration that may occur 

will only detract from the appearance of the 

pancake maker and will not affect the cooking 

performance. When cleaning the non-stick 

coating, do not use metal (or other abrasive) 

scourers. Wash with warm soapy water and dry 

thoroughly.
Remove stubborn residue using a damp cloth. 

SEASON THE PLATES

Season the plates occasionally to prevent 

sticking and to make cleaning easier. To 

season, brush the cooking plates with a little 

vegetable oil and rub off the excess with 

absorbent paper. Do this after preheating the 

unit. 
Do not use spray on non-stick coatings as this 

will affect the performance of the non-stick 

surface on the cooking plates.

NOTE

The cooking plates, hinges and overflow moat 

are coated with a non-stick surface, do not use 

abrasives.

STORAGE

To store your pancake maker:

1.  Ensure the power is off and then unplug 

power cord from the power outlet.

2.  Allow the pancake maker to fully cool.
3.  Wrap the power cord in the cord wrap area 

below the pancake maker. 

4.  Store on a flat, dry level surface.   

Do not place anything on top of the 

pancake maker.

WARNING

The handle is designed for opening and 

closing the pancake maker during cooking.  

It should not be used for moving or carrying 

the pancake maker.  
When moving the pancake maker, allow the 

unit to fully cool down and carry the unit via 

the base.