13
Humidity Level Setting
When the 2in1 Dehumidifier is turned on, the
current humidity level (%) will show on the
display screen and the light above the icon
will illuminate. This number will adjust as the
2in1 Dehumidifier operates.
The Humidity Level can only be set when
operating in Auto Mode and allows you to
manually set a relative humidity level (%RH)
between 30% - 80%.
1. Press either the or buttons to change
the humidity level in 5% increments with
each press. Stop once the desired humidity
level is displayed on the display screen.
Defrost
Defrost is an automatic maintenance function
that will only operate if a room temperature
falls to less than 23°C.
1. If the light on top of the icon turns on,
defrosting has automatically started. The
fan will operate on High during defrost
and any selected operating mode will
temporarily stop.
2. Automatic defrost will operate for up to
5 minutes.
3. Once Defrost is completed, the unit will
resume in the last selected operating mode.
WARNING
Do not disconnect the power or turn off the
unit during defrost.
WARNING
Do not use means to accelerate the defrosting
process or to clean, other than those
recommended in this instruction booklet.
EMPTYING CONDENSATE WATER
During the process of dehumidification, water
is created and needs to be expelled from the
2in1 Dehumidifier in one of two ways:
Water Tank Drainage
The removable 6.5L water tank will collect
water until it reaches the water level indicator
when the tank is full.
Once the water tank is full, the Empty Me
indicator light on top of the
icon will
illuminate, a buzzer will sound, and the unit
will stop automatically.
1. Remove the water tank from the unit.
2. Using the handle, transport the water tank to
a drainage source.
3. Tip the water tank and empty the water from
the hole located on the water tank lid (1A).
4. Replace the water tank back onto the unit.
The unit will resume automatically in the
last selected mode.
1A
