18
Care, Cleaning
& Storage
WARNING
Before cleaning or maintenance of the 2in1
Dehumidifier, ensure the power is switched
off at the outlet and the plug is removed.
CLEANING YOUR 2IN1 DEHUMIDIFIER
1. Keep the unit upright when cleaning.
2. Wipe the 2in1 Dehumidifier housing, control
panel and air inlet and outlet grilles with a
soft, dry cloth.
3. To remove dirt that may have built up on the
housing body and air inlet grille, wipe with
a damp cloth only. Do not use on the control
panel.
WARNING
Do not clean the control panel with a damp
cloth. Do not clean the unit with gasoline,
thinner or liquid detergent as chemical
substances may damage the screen or cause
discolouration on the unit.
NOTE
Do not use any objects that may scratch the
unit. For instance, using a brush may leave
scratches.
WATER TANK CLEANING
NOTE
The 2in1 Dehumidifier cannot operate if the
tank is full or is not installed correctly. Clean the
water tank once a week if used regularly.
1. Remove the water tank from the back of
the dehumidifier by holding the sides and
pulling outwards.
2. Remove the water tank lid before cleaning.
Place the tank on a dry, level surface. Flip
the handle on the water tank cover until the
grooves in the handle match the grooves in
the handle holders. Pull outwards on both
sides of the handle to disengage and remove.
Carefully pull upwards on the tank lid to
remove.
3. Tip any excess water from the water tank into
a sink or drain, then rinse the inside of the
tank with clean water.
4. Wipe any water on the outside of the tank
with a dry cloth and reassemble the water
tank lid and handle back onto the water tank.
5. Replace the water tank back into the 2in1
Dehumidifier.
