20
AntiViral HEPA-13 Cleaning
The AntiViral HEPA-13 filter sits within a
cavity at the back of the 2in1 Dehumidifier and
is held in place by the air inlet grille.
WARNING
Never wash the AntiViral HEPA-13 filter. This
filter can be cleaned by simply tapping over a
garbage receptacle.
NOTE
A dirty HEPA-13 filter may reduce the
performance of the 2in1 Dehumidifier. Clean
regularly and replace as needed.
1. Remove the air inlet grille to access the
AntiViral HEPA-13 filter. Gently separate
the filter from within the air inlet grille
using the tab provided. Tap the AntiViral
HEPA-13 filter over a garbage receptacle to
remove dust.
2. For optimal performance in air purification,
filter should be replaced every 4-6 months,
depending on the frequency of use.
AntiViral HEPA-13 Filter Replacement
Your Smart Dry™ 2-in-1 Viral Protect 2in1
Dehumidifier is also an effective air purifier
equipped with an AntiViral HEPA-13 filter
to help remove floating particles, allergens
and dust from the environment. For best
performance, the AntiViral HEPA-13 filter
should be replaced in the time frames
indicated below.
•
The AntiViral HEPA-13 filter life is
approximately 4-6 months based on 12 hours
daily operation or 2,160 hrs.
•
The filter life may vary to this timing,
depending on environmental conditions.
•
Remove all packaging from the replacement
filter before placing the filter into the unit as
described below.
1. Remove the air inlet grille to access the
AntiViral HEPA-13 filter.
2. Use the tab on top of the filter to separate
the used AntiViral HEPA-13 filter from the
air inlet grille, being careful that any residue
or debris that may fall from the filter does
not cause damage.
3. Remove the new AntiViral HEPA-13 filter
from the packaging material.
4. With the blue side of the filter placed facing
towards the air inlet grille, gently push
the filter in. The white tabs found on top
and bottom of the filter should be easily
accessible.
5. Replace the air inlet grille with filter back
into the 2in1 Dehumidifier before operating.
NOTE
If the filter is not in place or not fitted correctly,
the 2in1 Dehumidifier will not operate
effectively and may be damaged.
Replacement filters can be purchased from
the Breville website^ or at participating retail
outlets.
See the table below for the replacement
product code to suit this unit.
Breville 2in1 Dehumidifier
Model Number
Filter Replacement
Product Code
LAD708
LAD070
^Delivery charges may apply.
Please contact Breville Customer Service
Centre for further support.
Only use the original Breville filter specially
intended for this appliance. Do not use any
other filters.
STORAGE
1. Disconnect the 2in1 Dehumidifier from the
power outlet.
2. Ensure the water tank is empty and cleaned
as per instructions.
3. Clean the 2in1 Dehumidifier as per the
instructions found in this book.
4. Store upright and avoid standing in direct
sunlight if leaving for long periods.
5. Never store anything on top of the 2in1
Dehumidifier.
