12
troubleshooting
Problem
•
Cause/solution
Power indicator light does
not come on
•
Make sure that the unit is plugged in to the mains supply.
•
Turn the control lever to the HEAT UP position ( ).
•
Make sure that the milk tank assembly is pushed fully back
onto the unit because this activates a switch.
•
Check the fuse in the mains plug.
The power indicator
light does not come on
constantly.
•
The unit has not reached operating temperature yet. This takes
approximately 3 minutes, depending on the amount of water in
the boiler tank.
•
The unit does not have any power, see above.
•
The unit enters Standby mode if left turned on for 30 minutes.
Turn the control lever to the OFF position (
), then back to
the HEAT UP position ( ) to re‑activate.
The unit stops dispensing
coffee.
•
The milk tank has run dry. Refill the tank using the quick fill
funnel.
•
Power has failed. Check supply/fuse.
•
The unit enters Standby mode if left turned on for 30 minutes.
Turn the control lever to the OFF position (
), then back to
the HEAT UP position ( ) to re‑activate.
The coffee is not very warm. Allow the unit to reach full operating temperature before making
each cup. This is important if making more than one cup. The
power indicator light will stop flashing when the machine is at
operating temperature.
The unit makes a loud noise
and creates a lot of steam
while dispensing coffee.
•
The milk tank has run dry. Refill the tank using the quick fill
funnel.
•
Check that the milk pipe is fully inserted into the steam pipe.
Milk isn’t drawing into the
mixing chamber.
Make sure that the milk pipe is correctly fitted and that the milk tank
has not run dry.
Milk is leaking from the
mixing chamber.
Make sure that the mixing chamber lid is firmly locked in position
and that the chamber is fully inserted into the milk tank assembly.
Coffee continues to
dispense after the control
lever has been released.
A small amount of fluid will continue to be dispensed until all the
milk has left the mixing chamber. Please make allowances for this
when filling your cup.
Steam escapes from the
water boiler cap.
Make sure that the water boiler cap is fully tightened.
The power indicator light
keeps coming on and going
off.
The unit is fitted with a thermostat to maintain the temperature. It is
perfectly normal for the light to change between being constantly on
and flashing while the unit is in use.
The water boiler has run
dry.
Turn the unit off, then pour up to a maximum of 400ml of water into
the boiler. Secure the water boiler cap, switch the unit back on and
allow it to reach operation temperature and continue to dispense.
Summary of Contents for VCF041
Page 1: ...Breville Moments hot drink maker ...
Page 21: ...21 notes ...
Page 22: ...22 notes ...
Page 23: ...23 notes ...
