Breville VKJ884X, Instructions For Use Manual

5

USING YOUR KETTLE

1.  Remove the kettle from the power base and fill it with water 

either through the spout or through the opened lid. Don’t overfill 

the kettle and always ensure that there is sufficient water in the 

kettle (approx. 250ml)  for it to operate correctly (figure 1). 

2.  Check the level with the kettle on its power base (figure 2). 
3.  If removed, refit the lid and then switch the kettle on by moving 

the switch to the down position. Make sure that the lid is closed 

correctly to ensure safe operation (figure 3). 

4.  When the water reaches boiling point, the kettle will switch off 

automatically (figure 4). 

5.  You may also switch the kettle off manually at any time by 

moving the switch to the up

position (figure 5).

Always use caution when carrying the kettle when it is full of boiling 

water and when pouring it. 

WEEE

Waste electrical products should not be disposed of 

with household waste. Please recycle where facilities 

exist. E-mail us at enquiriesEurope@jardencs.com for 

further recycling and WEEE information.

GUARANTEE

Please keep your receipt as this will be required for any claims 

under this guarantee.
This appliance is guaranteed for 2 years after your purchase as 

described in this document.
During this guaranteed period, if in the unlikely event the appliance 

no longer functions due to a design or manufacturing fault, please 

take it back to the place of purchase, with your till receipt and a copy 

of this guarantee.
The rights and benefits under this guarantee are additional to your 

statutory rights, which are not affected by this guarantee. Only 

Jarden Consumer Solutions (Europe) Limited (“JCS (Europe)”) has 

the right to change these terms.
JCS (Europe) undertakes within the guarantee period to repair 

or replace the appliance, or any part of appliance found to be not 

working properly free of charge provided that:
•  you promptly notify the place of purchase or JCS (Europe) of 

the problem; and

•  the appliance has not been altered in any way or subjected to 

damage, misuse, abuse, repair or alteration by a person other 

than a person authorised by JCS (Europe).

Faults that occur through, improper use, damage, abuse, use with 

incorrect voltage, acts of nature, events beyond the control of 

JCS (Europe), repair or alteration by a person other than a person 

authorised by JCS (Europe) or failure to follow instructions for use 

are not covered by this guarantee. Additionally, normal wear and 

tear, including, but not limited to, minor discoloration and scratches 

are not covered by this guarantee.
The rights under this guarantee shall only apply to the original 

purchaser and shall not extend to commercial or communal use.
If your appliance includes a country-specific guarantee or warranty 

insert please refer to the terms and conditions of such guarantee or 

warranty in place of this guarantee or contact your local authorized 

dealer for more information.

Jarden Consumer Solutions (Europe) Limited

5400 Lakeside

Cheadle Royal Business Park

Cheadle

SK8 3GQ

UK

IF THE KETTLE BOILS DRY

If your kettle is operated with insufficient water a built in safety 

device will automatically switch it back off preventing damage. If this 

should happen:
•  Unplug your kettle and allow it to cool. When your kettle has 

cooled down sufficiently the safety device will reset itself.

•  Once the safety device has reset, refill your kettle with cold 

water and use it as normal.

CLEANING

1.  Unplug the kettle from the mains supply socket and allow it to 

completely cool down before cleaning or descaling it. 

2.  Clean the exterior surface of the kettle with a damp cloth and 

then polish with a soft dry cloth. Do not use steel wool pads or 

harsh/abrasive cleaners.  

3.  Descale your kettle regularly to keep it working efficiently. Use 

a descaling product following the manufacturer’s instructions 

carefully.

CLEANING THE FILTER

•  Unplug the kettle from the mains supply socket and allow it to 

completely cool down.

•  Open the lid and remove the filter from behind the spout (figure 

6).

•  Rinse the filter under a tap whilst brushing it with a soft brush 

(figure 7). 

•  In hard water areas it may be necessary to descale the filter 

using a descaling agent. Use a descaling product following the 

manufacturer’s instructions carefully. 

•  The filter may be washed safely in a dishwasher.
•  Refit the filter back into the kettle.