ASSEMBLE THE SUPPORT FRAMES
ASSEMBLING THE SUPPORT FRAME IS THE FIRST TASK. THE SIDE FRAMES ARE
ASSEMBLED FIRST AND THEN ARE CONNECTED TOGETHER WITH HORIZONTALS AT
THE BACK AND ADJUSTABLE X-BRACES TO MAKE IT RIGID.
ASSEMBLING THE SIDE FRAMES TOGETHER IS EASIEST IF THE LEFT FRAME IS
LEANING UP AGAINST A WALL. CHOOSE AN ASSEMBLY AREA NEAR THE THE FINAL
PLACEMENT. YOU WILL HAVE TO MOVE IT INTO PLACE AFTER ASSEMBLY.
NOTE THAT ONE OF THE TOP FRAMES HAS A WIRE. THIS IS THE RIGHT FRAME.
WHEN YOU ARE ASSEMBLING THE RIGHT FRAME, DROP THIS WIRE DOWN THE BACK
LEG OF THE BOTTOM FRAME AND FISH THE CONNECTOR OUT THROUGH THE LARGE
HOLE AT THE BOTTOM AFTER PRYING THE PLASTIC PLUG FROM THE HOLE. IF
NECESSARY, USE A PAIR OF NEEDLE-NOSE PLIERS OR A HOOK BENT FROM A
PAPERCLIP TO RETRIEVE THE CONNECTOR.
THE PLASTIC PLUG HAS SLITS THAT ALLOW THE PLUG TO BE PUSHED OVER THE
WIRE AND BACK INTO THE HOLE.
FINISHED SUPPORT
FRAME ASSEMBLY
ASSEMBLE THE LEFT SIDE
FRAME (THE ONE WITH NO
WIRES) FIRST, BY SLIPPING
THE TOP SECTION ONTO THE
BOTTOM SECTION (TWO
PERSON JOB). STAND THE
ASSEMBLED FRAME AGAINST
THE WALL.
BE CAREFUL TO ASSEMBLE THE
RIGHT WAY AROUND. THE
BACK OF THE TOP FRAME HAS
A HOLE LIKE THE ONE AT THE
BACK OF THE BOTTOM
SECTION.
WAIT TILL YOU HAVE THE
HORIZONTALS AND X-BRACES
ATTACHED TO THIS FRAME
BEFORE YOU PUT THE RIGHT
FRAME TOGETHER.
HOLE
HOLE
ATTACH THE HORIZONTALS
AND X-BRACING TO THE SIDE
FRAME WITH LONG BOLTS,
WASHERS, LOCKWASHERS AND
NUTS.
NOTES:
THE HORIZONTAL WITH A
BOARD ATTACHED IS AT THE
TOP.
THE LONG PART OF ONE
X-BRACE IS SANDWICHED
BETWEEN THE UPPER
HORIZONTAL AND THE FRAME.
THE SHORT PART OF THE
OTHER X-BRACE IS
SANDWICHED BETWEEN THE
LOWER HORIZONTAL AND THE
FRAME.
LEAVE THE BOLTS LOOSE, AND
LET THE PARTS JUST HANG
DOWN.
LONG SECTION
OF X-BRACING
SHORT SECTION
OF X-BRACING
Page 2
M6-V install manual
1-15-16
BAG: WM-2
