5
Treadwall®FT Owner’s Manual—2019
Rev Aug 2019
Operating Instructions
Digital Counter
The counter will start as soon as you begin climbing. It will pause if
you rest for 5 seconds, and it will power down after 5 minutes of non-
use. To turn the counter back on just start climbing, or tap the
screen.
You can adjust the view angle by adjusting the small arm at the rear
of the counter.
0
Calories
Time
0
Distance
0
Speed
0
Average Speed
Reset
Setup
?
Done
Distance Goal
?
Time Goal
Hold buttons above for
distance and time goals
Enter
weight
below
for
0
00:00
0
1 2 3 4 5
6 7 8 9 0
Clear
Home Screen
The home screen shows real-time data for a single climb. When
you pause for 5 seconds the counter will hold your data on the
screen until you begin climbing again and then it will start from
where you left off. To reset the counter for a new climber hit
“Reset.”
Setup Screen
To set a distance or time goal tap or hold the buttons labeled
“Distance Goal” or “Time Goal”. The values will increase more
rapidly as you hold the buttons down longer.
The number pad allows you to enter your weight for a more
accurate calorie count. The default weight is 150 pounds.
When you are satisfied with your goal, hit done and the value
you selected will appear on the home screen.
You can only select a distance or a time goal, not both at once.
Summary of Contents for TREADWALL Max Frame
Page 2: ......
