101381 H-Cable Replacement
For Brewer Assist High-Low Table
Document #101382 Rev A
7.8.2
Tools Required:
1/8” Allen Wrench
3/8” Nut Driver or Socket & Ratchet
5/16” Nut Driver or Socket & Ratchet
1/8” Flat Blade Screwdriver
3/8” Flat Blade Screwdriver
#1 Philips Screwdriver
Wire Cutters or Side Cutters
Pliers
Long Needle Nose Pliers
Adjustable Wrench
Plug unit into electrical outlet and turn power on
1.
Raise seat to the full up position. Note: If the seat lift is nonfunctional
2.
the seat may be raised using a lifting device designed for this purpose (the
seat section is 100 lbs). Be sure to utilize nonmarring straps, slings, or other
devices to prevent damage to the unit when lifting. Swing grab bars out of
the way to prevent damage by lifting device.
Box Shroud Removal:
Before proceeding with the next step,
turn power off at on/off switch at back of
rear cabinet and disconnect plug from the
electrical outlet!
WARNING
Support seat with a device rated for this purpose placed
3.
beneath it. Seat section is 100 lbs.
Remove the (2) box shroud bolts
4.
Support
Device
Box Shroud
Box Shroud
Bolts
