Fig. 6.
Filling the tank.
12.
To fill the water tank, pour three decanters of water into
the pour-in opening
(Fig. 6),
waiting approximately 1
minute between each decanter.
Note:
(For CCP models 1034525 & 1034526 only.)
Remove the top cover and pour the water directly in to
the reservoir.
13.
After pouring in the third decanter of water, water will
soon begin to flow from the brew cone into the decanter.
Wait until the water stops coming out of the brew cone.
14.
Empty the water from the decanter, and put the decanter
back on the warmer under the brew cone.
Electrical Connection:
Fig. 7.
Power connection.
15.
Connect the power supply cord
(Fig. 7)
into a proper power
supply as indicated on the electrical nameplate.
Warning:
Be certain the power supply is of the correct rating
and polarity before connecting the power supply cord. Failure
to heed this warning will void the warranty and may cause
damage or injury.
Turning The Coffee Brewer On:
16.
Push the "Power" switch
(Fig. 8)
to the on
(up)
position. The
switch will light when it is on.
Fig. 8.
Power switch.
Prepare The Coffee Brewer For Testing:
17.
Allow the coffee brewer to reach the proper brewing
temperature. The "Ready" light
(Fig. 9)
will come on when
the proper temperature has been reached. This will occur in
approximately 20 minutes.
Fig. 9.
Ready light.
Caution:
There will be a pressure buildup within the faucet
water line during this heat up period. To relieve this pressure,
slowly pull out the faucet handle and draw off a small amount
of water.
Fig. 10.
Start switch.
18.
Press the “Start” switch
(Fig. 10)
momentarily, and release it.
Allow the coffee brewer to complete the brew cycle.
Note:
Due to water expansion, there may be an overflow of
water, be prepared to contain this water.
Page 7
COMK211