2
Safety Instructions
⚫
Read all the instructions carefully and keep this manual for future reference.
⚫
Do not use the device if the cord or plug is damaged. It should be replaced before use.
⚫
Do not use an adaptor as the wattage power of this device is high.
⚫
Overloading the electric supply must be avoided.
⚫
As the device requires extra power, do not use extensions if under 13amp. No other products may be connected
to this extension.
⚫
Check the product's rating label and make sure the water urn voltage is fit for your outlet voltage before using.
⚫
The device must be only used as intended. It must be operated in a safe, fault-free condition. Ensure to check
the proper conditions prior to each use.
⚫
This appliance is fitted with a 13amp-16amp plug.
⚫
The appliance is only to be installed in safe locations.
Brewing Preparation
⚫
The device must be positioned on a stable, secure and horizontal support structure prior to use.
⚫
A full vessel contains boiling hot liquids and can weigh up to 40kg. Horizontal positioning is a prerequisite for
transfer pumping during the brewing process. Avoid an unsteady base.
⚫
The device may not be moved during the brewing process. The handles are only meant for transporting the
device in an empty state.
⚫
It is imperative to keep children, frail persons, and animals away from the device while it is in operation.
Remember boiling water is very dangerous.
⚫
Always clean all the parts of your brewing equipment, hygiene is imperative to get good brewing results.
⚫
Before use, it is optional to heat a quantity of hot water in the boiler to use for sterilizing brewing equipment etc.
Overflow Pipe Assembly
⚫
The mesh disc with 1 hole in the center is the bottom screen. Before placing the bottom screen into the grain
basket, untighten the bottom nut from the telescopic pipe and insert it to the bottom screen then tighten again the
nut as shown in the picture.
⚫
After the above steps, place the false bottom with telescopic pipe into grain basket.
⚫
Tighten the 2 small stainless handles to the upper disc as shown in the picture below
⚫
Adjust the ideal height of the overflow pipe according to the malt volume.
⚫
Place the cap cover onto the pipe when adding the brewing ingredients.
⚫
After adding your ingredients to the basket, remove the cap and slide the upper mesh disc onto the central pipe,
and lower onto the grain, with the 2 posts/handles facing upwards.
⚫
You are now ready to brew.