EN-2020-03
5 | 7
Tip: It is important that the electrical cords are put back at the same place as they were
before the work started. As a help, the electrical cords can be marked with a unique
number (1-4). Similarly, the same unique number can be written on the steel bottom.
This way you’ll be able to fit the electrical cords back where they were before the work
began.
4.
When the electrical cord has been removed from the brass connector, loosen the
heating element using a wrench or spanner on the main nut. Remember that when
both nuts have been removed, the heating element can drop down. It is therefore
recommended to hold the heating element while unscrewing the last nut.
5.
When the heating element has been removed, it is possible to either replace the
silicone gasket or replace the heating element with a new one. If replacing the
silicone gaskets, it is possible to take the opportunity to give the heating element a
solid scrub or do some mechanical adjustments. The bending radius of the heating
elements might increase slightly over time, - especially if they are run without being
submerged in liquid. Carefully use a suitable tool to decompress the turns to
decrease the overall bending radius of the heating element. Be careful not to overdo
it. Be careful not to scratch the surface of the heating elements.