EN-2020-03
6 | 7
Assembly
1.
Put the heating element back in place and use a wrench or spanner to fasten the nut.
Remember to refit the earthing ring lug. While fastening the nut, visually inspect the
deforming of the silicone gasket on the inside of the vessel to ensure a good fit and a
leak free connection.
2.
Ensure that the brass connectors are
fitted tightly to the heating element. It
should not be possible to turn them by
hand. Use two wrenches or spanners to
tighten the brass connector and the
small nut together to lock it properly. It
is important that the brass set screws
point towards the center of the
machine to enable easy access to the
set screws later. The brass connector
and the small nut should not touch the
ceramic ring.
3.
Put a piece of heat shrink tube on the electrical cord and put it into the brass
connector. Ensure that the whole tip of the electrical cord fits into the brass
connector. Use the 1.5mm Allen key and tighten the brass set screws. Pull the heat
shrink tube over the brass connector and all the way down. Use a heat shrink gun to
shrink the heat shrink tube so that it electrically isolates and seal the whole
connection area.