Loading And Unloading The Trailer
Bri-Mar
101
•
Return the dump body control to the battery box. Watch for and
avoid obstructions such as tree limbs, overhead lines, potholes, etc.
and SLOWLY drive the tow vehicle and trailer ahead to spread the
material.
•
DO NOT
drive forward and stop quickly to “shock” the load out of
the body.
DO NOT
“jerk” the control button up and down to
dislodge the load.
The proper procedure for a stuck load is to
fully lower the dump and dislodge the material by hand.
•
You may need to raise the dump body higher after a portion of the
load has been spread to place the remaining material at the rear of the
dump body.
•
Stop tow vehicle after all material has exited the dump body.
•
Press and hold button (4) to lower the dump body. See figure 5-7.
Release the button when the dump body is fully lowered. Place
dump body controller in the battery box and turn off wireless remote
(if equipped).
•
Close and latch rear gate before moving trailer.
5.4.4 Unload Bulk Material Using The Double Swing Gates
•
Read and understand the hoist operating procedure before dumping
the load.
•
Be sure the trailer is on level ground, both side-to-side and front-to-
rear. Attempting to unload on uneven ground may cause the trailer
to overturn, which can result in death or serious injury.
^
W
ARNING
Fully raising the loaded dump body may result in the tow vehicle rear
wheels loosing traction.
Do not fully raise a loaded dump body or place the entire load at the rear
of trailer.
Trailers
Summary of Contents for DT508LP
Page 144: ...Electrical Drawings Bri Mar 138 Trailers...
Page 145: ...Bri Mar 139 9 ELECTRICAL DRAWINGS Trailers...
Page 146: ...Bri Mar 140 Trailers...
