Coupling To The Tow Vehicle
Bri-Mar
80
^ Caution
The drop legs are heavily spring loaded in the lowered position. They
will rapidly return to the upper position when released and can inflict
serious bruises, scrapes or pinching.
Keep your feet, shins and hands well clear of the drop legs and drop leg
bases when releasing the drop legs.
Always wear shoes or boots while performing this operation
•
Be sure the plunger pin is fully engaged. Push it in by hand if
necessary. The bent part of the plunger pin handle must be touching
the plunger pin housing.
•
If your trailer has two drop leg jacks, lower them both to the same
level, following the above instructions.
Notice
If the drop legs are not set at the same level, one of the drop leg jacks can be
overloaded and can be damaged.
•
Release the handle (or crank) from its holder and engage it with the
jack shaft.
•
Rotate the handle (or crank) clockwise to slowly extend the jack and
transfer the weight of the trailer tongue to the jack.
•
On two speed jacks, pushing the handle shaft toward the gearbox can
perform rapid extension. This shifts the gearbox into a high speed
mode.
•
When the drop leg base contacts the ground, shift the gearbox into
low speed mode by pulling out on the handle shaft until it locks into
low gear.
Trailers
Summary of Contents for DT508LP
Page 144: ...Electrical Drawings Bri Mar 138 Trailers...
Page 145: ...Bri Mar 139 9 ELECTRICAL DRAWINGS Trailers...
Page 146: ...Bri Mar 140 Trailers...
