The iron clamping mechanism is controlled by the polished cap. When
raising the cap, the clamp arm lifts out of the way unlocking the iron
for removal. Moving the cap downward until it snaps will tighten the
iron.
Bevel up irons only need a small amount of pressure to keep the iron
bedded without chatter during cutting. When the iron clamping is
properly adjusted, the iron clamping mechanism will allow for both
iron cant and depth adjustment without unlocking the mechanism.
The iron clamping mechanism is adjusted at the factory. If it needs
adjusting, please follow the steps below to prevent damaging the
plane:
1.Pull up the cap to lift the clamp arm.
2.Turning the iron clamping knob counter-clockwise to fully loosen
the iron clamping.
3.Install a iron into the plane body and push down the cap as far as it
will go.
4.Turn the iron clamping knob clockwise until you first feel resistance.
5.An additional quarter turn of the iron clamping knob will tighten
against the iron. Additional quarter turns may be required to achieve
the optimal tightness which does not allow the iron to cant, or shift in
use.
DO NOT OVERTIGHTEN THIS MECHANISM AS YOU CAN DAMAGE THE
CLAMP ARM.
A bent clamp arm is a sure indication that the tool has been abused
and is not covered by warranty.
Iron Removal and Installation
CAUTION: The iron is sharp, take care when handling the iron to
prevent serious injury.
Summary of Contents for HP-9v2
