Bridge BRDSC01 v4
User Manual
19
Remote Management
Remote management is a feature that allows to control a Coiaca device remotely. Once this
feature is enabled and configured on the device, you will be able to send commands and
receive responses from the unit that lets you update configuration, perform operations and/or
simulate user intervention.
All these remote management tasks can be performed without interfeer on the main
functionality of the device. That is why Coiaca devices are perfect for service providers that
needs to control devices installed in places where physical access is difficult, restricted or
sometimes unreachable.
Remote management commands reference can be found on coiaca.com
The following are the parameters for the Remote Management feature:
Enable Remote Management
When enabled, Remote Management feature is enabled. Default value is YES (enabled)
Remote Management Password
The password to be included as “pwd” param in JSON payload in MQTT messages to issue a
Remote Management command.
This password is usually printed on a label sticked on the device. Be careful when updating this
password because if forgotten, it won´t be possible to control the device with Remote
Management until this password is reseted. For resetting this password, connect locally when
the device is acting as AP will be needed.
Remote Management MQTT server
The server the device will connect to listen for Remote Management commands and publish
command results. The connection to this server mandatory secure (TLS 1.2)
Remote Management MQTT server port (TLS)
Is the port Remote Management MQTT server listens for secured connections (usual and
default value is 8883)
Remote Management MQTT user
Username device will use to connect to Remote Management broker
Remote Management MQTT password
Password device will use to connect to Remote Management broker
Force all traffic through the secure connection
If enable, this option will force the device not to use the main MQTT server connection that is
unsecure. Only the broker specified for Remote Management will be used for all matters and
all traffic will take place though its secure connection.
Default value is YES (enabled)
