Copyright © Bridgetek Pte Ltd
11
PanLHub44/80 Datasheet
Version 1.0
Document Reference No.: BRT_000277 Clearance No.: BRT#146
5.5
LED Status Indicator
5.5.1
PanLHub44
The PanLHub44 has four RJ45 Port Indicators represented by LED1 to LED 4 and four RJ11 SNR1-SNR4
Port Indicators represented by LED5 to LED8. The LED will be green in normal operation mode if the port
is connected to any PanL device. Refer to the table below for the hub status represented by two system
health indicators-
5.5.2
PanLHub80
The PanLHub80 has 8 RJ45 Port Indicators represented by LED1 to LED 8. The LED will be green in
normal operation mode if the port is connected to any PanL device. Refer to the table below for the hub
status represented by two system health indicators-
Table 5
–
LED Status Indicator
5.6
Ethernet Port
Both PanLHub44 and PanLHub80 have an Ethernet port 10/100 BASE TX which can be used to connect
the hub to a local network through a regular network CAT cable.
5.7
RJ45 Port
5.7.1
PanLHub44
There are four RJ45 ports (PORT1 to PORT4) available on PanLHub44 which provides a communication
and power channel to any PanL devices at +24V DC.
A regular network CAT 8P8C cable can be used. Ensure that the length of the RJ45 8P8C cables does not
exceed 100 Metres from the port to the last wired PanL device. In the event that a single port is used to
power up a few PanL devices in a daisy chain configuration, the first connection to a PanL device and the
subsequent connections between the PanL devices must not exceed 50 metres in cable length. The total
combined cable length must not exceed 100 metres. A maximum of two PanL devices are allowed for
daisy chain if there are more than one PD70, PD70PLUS or PD50 device or any combination of these
present. Any other combinations will have a maximum limit of three devices.
