2.3.2
Using a Copper Interface Cable (SFP+)
If you are using a copper based solution, an SFP+ Direct Attach Copper (DAC) Twin-Ax interface
cable must be used; the maximum supported length of which is a 7 meter passive cable.
To connect the Appliance directly to a device, insert one or two SFP+ cables in to the connector as
shown below. When the plug is connected a “click” should be heard.
Note: Speeds other than 10Gb/sec may not be supported by your 10Gb NIC.
2.3.3
Using a 10GBASE-T Category 6 or 6a Cable (RJ45)
If you are using a copper based solution using the RJ45 connector, a Category 6 or 6a Ethernet
cable is required, with a maximum length of 55 meters for Category 6 and 100 meters for Category
6a.
To connect the Appliance to an Ethernet network or directly to a device, connect one side of the
Category 6 Ethernet cable into a RJ45 port located on a 10 Gigabit Ethernet card at the back of the
unit. When the plug is in the correct position, a “click” should be heard. Connect the other side of
the cable to your Ethernet network or device.
2.4
Connecting the 40Gb QSFP Cables
To connect the Appliance to your network for iSCSI transfer, you will require a copper QSFP cable.
The 40Gb ports are located at the back of the Appliance, as shown below:
11
