2021 Owner’s Manual Navigator24
BRIG ltd
34
3.Disengage safety pin (6) from chain.
4.Set the windlass circuit breaker (8) to the ON position. To do this, move the lever switch (8b) to the upper
position by pressing it from the bottom up
until it locks.
5.By means of anchor windlass "DOWN" switch (9) (steering console, dashboard) drop the anchor.
6.After anchoring the boat, close the bow anchor hatch (10).
If you need to raise the anchor by electric windlass:
1.Set the windlass circuit breaker (8) to the OFF position (steering console, starboard side).
To do this, press the
button (8a). In this case, the lever switch (8b) will move to the down position.
2.Open the bow anchor hatch (10). By means of special handle close the clutch nut (3).
3.Check that the safety pin (6) is detached from chain.
4.Set windlass circuit breaker and battery disconnectors to the ON position.
5.By means of anchor windlass "UP" switch (9) begin to raise the anchor.
6. When the anchor will begin to crawl on a roller, stop windlass electric motor in order to make sure that the
anchor is not swinging and have occupied correct position. CHECK, THAT THE ANCHOR OCCUPIED CORRECT
POSITION (Fig. 14).
7.Continue to stow the anchor, until it will be fixed on a rollers.
8.Switch OFF the windlass circuit breaker (8).
9.Hook safety pin (6) to chain. Close the bow anchor hatch (10).
In the event of overloads in the anchor system, the circuit breaker (8) can set itself (automatically) to the OFF
position. In this case, you can turn ON the circuit breaker only after eliminating the reason for turning it off.
Anchoring is easier with another person on board. First be certain that the line for the anchor is properly attached, to avoid
losing the anchor and anchor line overboard. The end of the anchor line opposite to the anchor is fixed to the boat hull.
The anchor line consists of a stainless steel chain and nylon rope.
Chain will stand up to the abrasion of sand, rock, or
mud on the bottom. Nylon rope will stretch under a heavy strain cushioning the impact of waves or wind on both the boat
and the anchor.
To drop the anchor, select a well protected area, preferably with a flat bottom.
