Not for
Reproduction
7
5. Disconnect garden hose from water inlet. Disconnect
high pressure hose from gun and high pressure outlet.
6. Drain water from hose and spray gun, and wipe off
exterior surfaces.
7. Drain water from pump by tipping unit onto its right
side (water inlet facing down) for two minutes. Flip
unit over and let rest on high pressure outlet for an
additional two minutes.
8. Wrap high pressure hose on top hook of accessory tray.
9. Coil power cord on bottom hook of accessory tray.
Store spray gun, nozzle extension and 7-in-1 nozzle
on accessory tray.
10. Store unit in a clean, dry area.
11. If storing for more than 30 days, see Storage.
Maintenance
General Recommendations
Regular electric maintenance will improve performance
and extend the life of the pressure washer. See any
Briggs & Stratton Authorized Service Dealer for service.
DO NOT allow children to clean or maintain without supervision.
The electric pressure washer’s warranty does not cover
items that have been subjected to operator abuse or
negligence. To receive full value from warranty, operator
must maintain pressure washer as instructed in this
manual, including proper storage as detailed in
Storage
.
WARNING!
To ensure machine safety, use only
original spare parts from the manufacturer or approved
by the manufacturer. Should you have questions about
replacing components on your pressure washer, please visit our
website at BRIGGSandSTRATTON.COM. If cord is damaged,
see an Briggs & Stratton Authorized Service Dealer.
Nozzle Maintenance
Clean nozzle to correct excessive pump pressure caused
by a clogged spray nozzle:
1. Press master ON/OFF switch to OFF (0) position.
Remove power cord plug from electrical outlet.
2. Remove 7-in-1 nozzle from end of nozzle extension.
3. Use a small paper clip to free foreign material clogging
or restricting nozzle.
4. Reinstall 7-in-1 nozzle into nozzle extension.
O-Ring Maintenance
Figure
10
The use of lubricant (petroleum or synthetic grease) helps seat
o-rings providing an improved seal. Apply lubricant to o-rings
prior to assembling high pressure hose (
A
), garden hose to
the pump (
B
), spray gun (
C
), and nozzle extension (
D
).
Purchase an O-Ring Maintenance Kit by contacting a Briggs
& Stratton Authorized Service Dealer. NEVER repair leaking
connections with sealant of any kind. Replace o-ring or seal.
PRCD Fuse Replacement
Figure
11
WARNING!
To reduce the risk of fire, replace only with
13-amp BS 1362 rated fuse.
If equipped with fuse within PRCD:
1. Locate fuse on pin side of PRCD plug.
2. Using a flat-head screwdriver, remove cover (
A
) and
fuse. Remove fuse (
B
) from cover. Replace fuse with
13-amp BS 1362 rated fuse.
3. Insert cover and fuse.
Storage
Follow steps 1-10 in
After Each Use.
NOTICE
Water left in pump could freeze and permanently
damage pump. Freeze damage is not covered under warranty.
Protecting the Pump
To protect the pump from damage caused by mineral
deposits or freezing, use PumpSaver to prevent freeze
damage, and lubricate pistons and seals.
NOTICE
Failure to protect unit from freezing termperatures
will damage pump and render unit inoperable. Freeze
damage is not covered under warranty.
Final Storage Tips
1. Wrap high pressure hose on top hook of accessory tray.
2. Coil power cord on bottom hook of accessory tray.
3. Store spray gun, nozzle extension and 7-in-1 nozzle
on accessory tray.
4. Cover unit with a protective cover that does not retain
moisture and store in a clean, dry area protected from
freezing temperatures.
