5
2
Installation
WARNING
Disengage the electric clutch (PTO). Shut off the engine,
remove the key, and wait for all moving parts to stop before
attaching, adjusting, or disconnecting any part of the
c
atcher
system.
• Unless specified, use the applicable tools to tighten the
hardware.
• Fold the seat forward for the entire assembly process.
• Do not use the removed hardware in the installation.
• Put the mower into the lowest position.
It is important to complete the removal and installation of the
hardware on the left side of the draw bar before the removal
and installation of the hardware on the right side.
Install the Side Plates
Broadmoor™
1600/2600 LT Series, CTX 9000
Use the Hardware Parts Bag: AA
1. Attach the side plate (A, Figure 3) to the side of the frame
with the capscrews (B) and flange locknuts (C). Repeat
for the other side.
3
Install the Mounting Spacers
Broadmoor without Suspension
1600/2600 LT Series, CTX 9000 Models
Use the Hardware Parts Bag: BB
1. Install the spacers (F, Figure 4) to the rear of the side
plates (A) with the capscrews (D), washers (E) and
nylock nuts (G). Repeat for the other side.
2. Install the spacers (F) above the side plates (A) with the
capscrews (D), washers (E) and nylock nuts (G). Repeat
for the other side.
Not for
Reproduction
