8
15
Install the Cross Support, C
atche
r Bags
and Cover Assembly
Install the Cross Support
Use Hardware Parts Bag: CC
1. Position the cross support (L, Figure 16) onto the upright
support assembly (O). Install and tighten the carriage
bolts (H) and flange nuts (I).
16
Attach the Catcher Bags
1. Attach the catcher bags (N, Figure 17) to the tabs (a) on
the cross support assembly.
17
Attach the Cover Assembly
Use Hardware Parts Bag: CC
1. Put the corner brackets (a, Figure 18) on the cover
assembly (M) onto the pivot hinges (b). Install the hinge
pins (J) and hair pins (K).
18
Install the Catcher Boot Kit / Turbo Kit
WARNING
DO NOT operate the unit without either the entire grass
catcher or the deflector in place.
Install the catcher boot kit or turbo kit (supplied separately)
designed for the mower deck on your rider. Refer to the
catcher boot kit or turbo kit manual.
Not for
Reproduction
