16
Operating the Tractor
If an operator chooses to mow in reverse, the RMO system can
be used. To use the Reverse Mowing Option (RMO) turn the
RMO key after the PTO is engaged. The L.E.D. light will
illuminate, and the operator can then mow in reverse. Each time
the PTO is disengaged the RMO needs to be reactivated if
desired. The key should be removed to restrict access to the
RMO feature.
Attachment Operation in Reverse
If an operator chooses to operate a PTO driven attachment in
reverse, the RMO system can be used. To use the Reverse
Mowing Option (RMO) turn the RMO key after the PTO is
engaged. The L.E.D. light will illuminate, and the operator can
then operate the attachment in reverse. Each time the PTO is
disengaged the RMO needs to be reactivated if desired. The
key should be removed to restrict access to the RMO feature.
Pushing The Tractor By Hand
Two Wheel Drive Models (2WD)
1. Disengage the PTO and turn the engine off.
2. Pull the transmission release back approximately 2-1/2”
(6 cm) to lock into released position (Figure 2.1).
3. The tractor can now be pushed by hand.
Driving The Tractor
1. Sit in the seat and adjust the seat so that you can
comfortably reach all the controls and see the dashboard
display.
2. Engage the parking brake.
3. Make sure the PTO switch is disengaged.
4. Start the engine (see STARTING THE ENGINE).
5. Disengage the parking brake and release the brake pedal.
6. Depress the forward ground speed control pedal to travel
forward. Release the pedal to stop. Note that the further
down the pedal is depressed the faster the tractor will travel.
7. Stop the tractor by releasing the ground speed control
pedals, setting the parking brake, and stopping the engine
(see STOPPING THE TRACTOR AND ENGINE).
Mowing
1. Set the mower cutting height to the desired level and set the
gauge wheels to the appropriate position (if equipped).
2. Engage the parking brake. Make sure the PTO switch is
disengaged.
3. Start the engine (see STARTING THE ENGINE).
4. Fully lower the mower using the attachment lift lever.
5. Set the throttle to FULL.
6. Engage the PTO (Mower Deck).
7. Begin mowing. When the “catcher full” alarm sounds, turn
off the PTO immediately to prevent discharge tube plugging.
Travel to the desired location and empty the catcher.
8. When finished, shut off the PTO and raise the mower using
the attachment lift control lever.
9. Stop the engine (see STOPPING THE TRACTOR AND
ENGINE).
Mowing in Reverse
Figure 2.1. Transmission Release Lever (2WD)
A. Fuel Tank Cap
B. Transmission Release Lever
B
A
DO NOT TOW TRACTOR
Towing the unit will cause transmission damage.
• Do not use another vehicle to push or pull this unit.
• Do not actuate the transmission release valve lever
while the engine is running.
WARNING
The engine will shut off if the reverse ground speed
pedal is depressed while the PTO is on and the RMO
has not been activated. The operator should always
turn the PTO off prior to driving across on roads, paths
or any area that maybe used by other vehicles. Sudden
loss of drive could create a hazard.
WARNING
Mowing in reverse can be hazardous to bystanders.
Tragic accidents can occur if the operator is not alert
to the presence of children. Never activate RMO if
children are present. Children are often attracted to the
unit and the mowing activity.
Not
for
Reproduction
