5
WARNING
Spraying flammable or combustible liquids can
cause fire or explosion.
Compressor produces sparks during operation,
which can ignite flammable or combustible
vapors.
• DO NOT spray flammable or combustible liquids while smoking,
near sparks, open flames, pilot lights, any ignition source, or in
confined areas.
• Spray in an open, well ventilated area at least 20 feet
(6.1 meters) away from compressor or other ignition source.
WARNING
Contact with compressor or its cord can cause
electric shock or burn.
Improper grounding can result in electrical
shock.
Contact with components under protective cover
can cause electric shock or burn.
• DO NOT use grounding adapters. Inspect cord before each use.
• DO NOT operate with protective covers / guards removed or
damaged.
• DO NOT operate in wet conditions. Store unit indoors.
• Disconnect from power source and drain pressure from tank
when not in use or before servicing.
• DO NOT modify the plug provided. If it does not fit the available
outlet, a qualified electrician should install a proper outlet.
• A qualified electrician MUST make repairs to the cord set or
plug.
WARNING
Failure to read and follow instructions in
Operator’s Manual can result in death, bodily
injury and / or property damage.
• Before using this product, read this Operator’s Manual and
follow all Safety Rules and Operating Instructions listed.
• Make this manual available to other users of this equipment.
WARNING
Hidden internal tank corrosion can cause violent
explosion leading to severe injury and / or
property damage.
Exceeding pressure rating of attachments or
inflatables can cause severe injury and / or
property damage.
Tampering with or removing ASME Safety Valve
can cause explosion leading to severe injury
and / or property damage.
• DRAIN TANK after every 4 hours of use or daily by opening
drain fitting(s) and tilting compressor to empty accumulated
water.
• DO NOT modify or repair tank in any way.
• DO NOT adjust pressure greater than maximum rating of
attachments or inflatables.
• DO NOT tamper with or remove ASME Safety Valve. Check
ASME Safety Valve by pulling ring before each use. ASME
Safety Valve has been set to maximum safe rating.
