7
Assembly
Unpack Air Compressor
1. Remove everything from carton except air compressor.
2. Lift air compressor out of carton.
Items in the carton include:
• Air Compressor
• Bottle of Compressor Pump Oil
• Oil Dipstick
• Operator’s Manual
If any of the above parts are missing or damaged, call the
helpline at
(800) 743-4115
.
Also recommended for use:
• Safety glasses (ANSI Z87.1 approved safety glasses
with side shields)
• Air hose - 25 ft (7.6M), 3/8 inch diameter
• Quick connector fitting - Use type I/M quick connect
fittings that attach to 1/4 inch NPT thread
• Hearing protection (ANSI S3.19-1974) in noisy
environments
• Respirator (NIOSH-approved) in dusty environments
• Oil funnel
Your compressor is ready for use when:
Properly serviced with supplied oil
Connected to a suitable power source
Completed Break-In Procedure
Add Oil
1. Place compressor on a flat, level surface.
2. Remove and discard the shipping cap. Using an oil
funnel, slowly fill pump with oil to notch on dipstick.
3. Reinstall dipstick (
A
) into oil fill opening (
B
).
4. Carefully remove dipstick and verify that oil level is at
proper level (
C
).
5. If oil level is too low, slowly add recommended oil into
oil fill to proper level on dipstick. If oil is above
MAXIMUM oil level (
D
), drain excess oil, as described
in
Pump Oil
.
6. Reinstall oil dipstick.
NOTICE
Serious damage may result if operating the unit with
insufficient oil. Check oil level daily or with each use.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
Inset of
Dipstick
B
D
C
A
