ENGLISH
Check Spray Nozzle.
A clogged spray nozzle can cause the spray pressure and flowrate
to drop. All excessive pressure will go back to the sprayer tank.
To correct the problem, immediately clean the spray tip by
following these instructions:
1. Stop engine & remove the unit from the operators back.
2. Disconnect the spray wand from the Spray hose assembly.
3. To remove the nozzle cap (N/P), turn in anticlockwise direction.
4. Inspect and clean the spray tip (O/Q) and metal strainer (R)
for 3 nozzle spray wand from any foreign material clogging or
restricting the spray nozzle. Replace if damaged.
5. Reinstall the nozzle cap and the spray wand with the spray hose
assembly tighly (hand tighten) .
Checking Pump Oil Level
Oil level should be checked prior to each use.
1. Make sure the backpack sprayer is on a level surface.
2. To get access to the back of the pump, you need to unbutton
the top backpad only.
3. Verify the oil is showing as 3/4's full (approx. 140ml) in the
oil glass window.
4. Replace and re-button the backpad into place before using.
NOTICE
DO NOT attempt any oil maintenance on this pump.
The pump is pre-lubricated and sealed from the factory. If
refilling is required, see an Authorized Dealer or Service Centre.
NOTICE
Do not use pressurized air or solvents to clean the
filter as the filter can be damaged.
T
S
U
Tongue
location
3 nozzle spray wand
Single nozzle spray wand
N
O
P
Q
R
WARNING
Gasoline and its vapors are extremely
flammable and explosive. Fire or explosive
can cause severe burns or death.
• Never start or run the engine with the air cleaner assembly
removed or with the air filter removed.
• Never clean the air filter with petrol or inflammable solvents.
• Always switch off the machine and disconnect spark plug H.T
lead before carrying out any maintenance work.
Air Cleaner Maintenance
Rubber seal
Rubber seal
19
1. Remove the retaining knob (S) from air filter cover (T).
2. Remove air filter cover (T) and the filter element (U).
3. Clean the filter element by washing in soapy water and
allowing it to dry completely.
4. Soak in a mixture of 25:1 two stroke oil and squeeze off
excess.
5. Assemble in reverse order.
NOTICE
Make sure the air filter element and cover are fitted
correctly. DO NOT operate the engine without the air filters
element and cover fitted. Warranty coverage will be void if
engine is damaged due to incorrect installation of the air filter.
Not for
Reproduction