Generac Portable Products 3250 Watt Generator
6
ASSEMBLY
Your generator requires some assembly and is ready for
use after it has been properly serviced with the
recommended oil and fuel.
If you have any problems with the assembly of your
generator, please call the generator helpline at
1-800-270-1408. If calling for assistance, please have the
model, revision, and serial number from the data tag
available.
Remove Generator From Carton
• Set the carton on a rigid flat surface with “This Side Up”
arrows pointing upward.
• Carefully open the top flaps of the shipping carton.
• Cut down corners at one end of carton from top to
bottom and lay that side of carton down flat.
• Remove all packing material, carton fillers, etc.
• Remove the generator from the shipping carton.
Install Wheel Kit
To install wheel kit you need the following tools:
• 15/16" (22mm) box, open end, or socket wrench
• Two 13mm box, open end, or socket wrenches
Install Wheel Kit as follows: (Refer to Figure 1)
• Place bottom of generator cradle on a flat surface.
• Place axle stud through wheel retainer on cradle frame.
• Use 15/16” wrench to secure the axle stud to frame
with 5/8-18 jam nut.
• Install the other axle stud in the same manner.
NOTE: Be sure to install wheel with raised hub inboard.
• Tip unit and install the wheel. Place flat washer over axle
stud.
• Retain wheel on axle stud with retaining pin. Install other
wheel on remaining axle shaft the same way.
• Attach the vibration mount to the mounting leg with a
capscrew and lock nut.
Capscrew
Handle
Grip
Nut
Mounting Leg
Use Existing Fasteners
to Secure Leg
Jam Nut
Retaining Pin
Wheel
Washer
Axle Stud
Figure 1 — Installing the Wheel Kit
Capscrew
Vibration Mount
Nut
