Document: - page 11 (Black)
Screen angle and frequency: 45.0000, 150.0000
11
STARTING AND STOPPING
ELECTRIC STARTER (if equipped)
[1.] Check oil level.
[2.] Turn
fuel shut-off valve (if equipped) 1/4 turn to
OPEN.
[3.] Push safety key IN (if equipped).
[4.] Turn rotary choke knob to CHOKE position.
[5.] Depress primer.
Note:
If temperature is 15
°
F (–9
°
C) or higher push
primer
two
times, if below 15
°
F (–9
°
C) push prim-
er
four
times.
[6.] Move throttle to FAST position. Operate engine
with throttle in FAST.
[7.] Connect power.
[8.] Depress starter button.
[9.] Allow engine to warm up several minutes, adjusting
choke toward RUN position. Wait until engine runs
smoothly before each choke adjustment.
[10.]
IMPORTANT:
After engine starts, unplug exten-
sion cord from starter.
Fuel shut-off
Rotary Choke Knob
(Top) and Primer
OPEN
POSITION
Throttle Control
Safety Key
To Start Engine:
Intek
E
Snow MODELS 120000, 200000, 210000
CAUTION:
To prolong starter life, use short starting cycles
(5 seconds maximum, then wait one minute).
Follow equipment manufacturer’s recommenda-
tions for charging battery.
Electric Start Button
3-WIRE
RECEPTACLE
3-PRONG
GROUNDED PLUG
WARNING
•
Use a 3-wire extension cord.
•
Plug cord into starter motor first, then into wall
receptacle. If additional extension cord is required,
use a 3-wire.
•
If the supply cord is damaged, it must be replaced by
the manufacturer or its service agent or a similarly
qualified person in order to avoid a hazard.
[1.] Move throttle control to SLOW, then to STOP.
[2.] Pull safety key OUT (if equipped).
[3.] Close fuel shut-off valve (if equipped).
To Stop Engine:
Summary of Contents for Industrial Plus Snow 90000
Page 20: ......