Balancer Cube
Operator's manual
3
3
GB
8.2 Selection of the static imbalance display
To view the static imbalance, press [F+P2]
. The machine will show the static imbalance
value on the display as seen in figure F8.1 and the LED next to the button lights up.
Fig. F8.1 View of the Static imbalance display enabled. The right display indicates the entity of the
static imbalance.
To return to the dynamic imbalance display, press [F+P2]
again. The LED next to the
button will turn off.
Note:
I
n some cases, static imbalance is forcibly set by the machine according to the current settings. For example,
if the MOTO Wheel Type program is enabled and the width set is less than 4.5 inches, the machine will auto-
matically set the static imbalance display.
8.4 Illuminator (only in some machine models)
The illuminator is quite useful because it allows shedding light on the internal part of the rim which
is normally barely visible, thus making balancing operations easier.
+
+
To turn on the illuminator, press [F+P9]
. To turn off the illuminator, press [F+P9]
again.
The illuminator is also automatically managed by the machine that turns it on in the following cases:
• When the Distance/Diameter sensor is extracted;
• After a wheel stop procedure on the position of imbalance (SWI procedure) which resulted in the balancing
position of the internal weight;
• When the wheel itself is in the balancing position of the internal weight by manually rotating the wheel
after a launch;
+
+
Summary of Contents for OSPREY BP63
Page 1: ...BP63 OSPREY...
