Use and Maintenance Manual – VER. 2016-02
Page 18
The positions of the weights along the section of the rim are the same as those shown in figure F16.1.
16.3 Entering wheel size
The dimensions of the wheel to balance can be entered in two ways:
Manual Mode.
Semi-automatic Mode.
Note: All machines are equipped with a graduated scale for manually measuring distance.
16.3.1 Manual entry of wheel dimensions for the STD and Program Types
To manually enter a wheel size, proceed as follows:
1.
Fit the wheel on the shaft and tighten it with the ring nut.
2.
Extract the distance sensor and place it on the wheel as shown in Picture F16.2.
3.
Read the distance value on the graduated scale as shown in Picture F16.2. The distance value is always expressed in
millimetres.
4.
Press [P1] key
to change distance and then press the [P4]
or [P5] key within 1.5 seconds
to enter the read value. If you do not press the [P4] or [P5] key within this time limit, the machine will
return to the previous display. In this case, you can press the [P1] key again
to enter or edit the data.
5.
Measure the width of the wheel with the special gauge or read the value of the width indicated on the rim. The value of
the width can be in inches or millimetres according to the selected unit of measurement.
6.
Press the [P2] key
to change the width and press the [P4]
or [P5] key within 1.5 seconds
to enter the read value. If neither of these two buttons is pressed in this time limit, the machine will return
to the previous display. In this case, you can press the [P2] key again
to enter or edit the data;
7.
Read the value of the diameter indicated on the rim or tyre. The value of the diameter can be in inches or millimetres
according to the selected unit of measurement.
8.
Press the [P3] key
to change the diameter value and then press the [P4]
o [P5]
within 1.5 seconds to enter the read value. If neither of these two buttons is pressed in this time limit, the machine will
return to the previous display. In this case, you can press the [P3] key again
to enter or edit the data.
Picture F16.2: Manual acquisition of wheel dimensions: placing the Distance sensor
Summary of Contents for VULTURE BP46
Page 1: ...BP46 VULTURE ...
