Use and Maintenance Manual – VER. 2016-02
Page 21
Picture F16.5: Manual acquisition of the external plane distance in ALS1 and ALS2 Program Types
16.3.3 Automatic acquisition of the wheel dimensions for STD Program Types
To automatically introduce the wheel size data, proceed as follows:
1.
Fit the wheel on the shaft.
2.
Extract the Distance/Diameter sensor and place it on the rim as shown in picture F16.6;
3.
Wait to hear the long acquisition beep and then set the Distance/Diameter sensor back to the rest position;
4.
Manually introduce the rim width. The width of the rim is normally printed on the rim itself. Alternatively use the
appropriate width measuring gauge.
Picture F16.6: Automatic data acquisition in STD programs
16.3.4 Automatic acquisition of the wheel dimensions for the ALS1, ALS2 program types
To automatically enter the dimensions of the wheel in the ALS1 and ALS2 program types proceed as follows:
1.
Fit the wheel on the shaft.
2.
Extract the Distance/Diameter sensor and place it on the plane chosen as the internal plane. The position is different
depending on the programs selected ALS1 or ALS2. See pictures F16.7 and F16.8;
3.
Wait to hear the long acquisition beep and then set the sensor back to the rest position;
4.
Extract the Distance/Diameter sensor and place it on the plane chosen as the external plane. See picture F16.9;
5.
Wait to hear the long acquisition beep and then set the sensor back to the rest position;
6.
The dimensions of the wheel have been acquired and the values can be displayed and/or modified by pressing [P1]
for the di1/di2 values (internal/external plane distance) and [P3]
for the da1/da2 values
(internal/external diameter plane).
Picture F16.7: Automatic acquisition of the internal plane distance and diameter in ALS1 Program Type
Summary of Contents for VULTURE BP46
Page 1: ...BP46 VULTURE ...
