Use and Maintenance Manual – VER. 2016-02
Page 22
Picture F16.8: Automatic acquisition of the internal plane distance and diameter in ALS2 Program Type
Picture F16.9: Automatic acquisition of the external plane distance and diameter in ALS1 and ALS2 Program Type
Note: acquisition of the inner position is confirmed by a long beep followed by a short beep while the acquisition of the outer
position is confirmed by a long beep followed by two short beeps.
16.4 Use of the special program types for ALS1 and ALS2 aluminium wheels
The machine has two special Program Types for aluminium wheels called ALS1 and ALS2.
These two programs allow the user to select the planes for balancing weight application. This allows balancing aluminium wheels
having particular shapes, difficult to perform with standard program where the weight are applied in precise positions.
The difference between ALS1 and ALS2 program is that in ALS1 Program Type the user could select freely the outer balancing
positions (inner position) instead in ALS2 Program Type the user could select freely both of balancing positions.
The ALS1 or ALS2 program types use only the Distance/Diameter sensor to acquire the balancing planes chosen by the user. The
width sensor is not used.
The use of the ALS1 or ALS2 program types is divided into three parts:
Acquisition of balancing planes;
Balancing spin;
Search of the balancing planes for weight application.
Note: guided acquisition and research of balancing planes could be performed only if the Distance/diameter sensor is installed and
enabled. If these conditions do not occur follow the instructions described on paragraph 16.4.4 Use of the ALS1 or ALS2 program
types without automatic acquisition.
16.4.1 Acquisition of the balancing planes
At this stage the balancing positions are acquired. During the acquisition two pairs of values about distance and diameter are
stored. These pairs are named
di1
and
da1
(distance 1 and diameter 1) for the internal plane and
di2
and
da2
(distance 2 and
diameter 2) for the external plane. After performing the acquisition it is possible to display (and also modify) these pairs of values
by pressing [P1] key
for the distance and [P3] key
for the diameter.
Summary of Contents for VULTURE BP46
Page 1: ...BP46 VULTURE ...
