Use and Maintenance Manual – VER. 2016-02
Page 26
The Hidden Weights program is used for aluminium rims when:
You want to hide the external weight behind two spokes for aesthetic reasons;
The position of the external weights coincides with a spoke therefore a single weight cannot be applied.
NOTE: This program can be used with any Program Type and with any Wheel Type. It can also be used to divide the static weight
into two separate weights (especially useful with wheels for motorbikes).
Hidden Weights Program with disabled sensor
To use this program, proceed as follows:
1.
Perform wheel balancing without applying the external weight.
2.
Rotate the wheel manually until all external imbalance search LEDs light up (see detail [9] in Picture F17.1).
3.
For easy of use make a reference mark on the tyre in the imbalance position at 6 o’clock;
4.
Press [F+P5]
to run the Hidden Weights program. If the wheel is balanced on the external
side, the machine will display error code Err 050 to indicate that the operation is not allowed.
5.
If instead there is an imbalance on the external side, the machine will display the message shown in Picture F17.2.
Picture F17.2 W1 weight position input
NOTE: You can exit the “Hidden Weights” program at any time by pressing [F+P5].
6.
Manually rotate the wheel anticlockwise up to the point where you want to apply the external weight W1, and press [P1]
to confirm. The angle formed by W1 and by the initial external weight W must be less than 120°.
7.
If the angle chosen is higher than 120° the machine displays the error code Err 051, indicating another point of choose. If
instead the angle is less than 120°, the machine will display the message shown in Picture F17.3, allowing the operator to
continue with the next step.
Picture F17.3: Input of the weight W2 position
NOT VALID!
The angle between weights W1
and W2 is ≥ 120°.
NOT VALID!
External imbalance W is not within
W1 and W2.
VALID
The angle between weights
W1 and W2 is < 120° and
includes
initial
external
weight W.
Summary of Contents for VULTURE BP46
Page 1: ...BP46 VULTURE ...
