INSTALLATION GUIDE
Actual product characteristics may vary. Bright Light reserves the right to improve, modify or update the product designs without prior notice.
8
14
20
10
ACCESSORY
CODE
ALUMINIUM MOUNTING CLIP
20mm
BL-LS-4315
HOLE DIMENSIONS Ø2.5mm
ACCESSORY
CODE
SINGLE END FEED KIT
Includes A + C + 1m cable
BL-LS-4320
SINGLE BOTTOM FEED KIT
Includes B + C + 1m cable
BL-LS-4321
DOUBLE END FEED KIT
Includes A + A + 2 × 1m cable
(for double power feed*)
BL-LS-4322
DOUBLE BOTTOM FEED KIT
Includes B + B + 2 × 1m cable
(for double power feed*)
BL-LS-4323
END & BOTTOM FEED KIT
Includes A + B + 2 × 1m cable
(for double power feed*)
BL-LS-4324
SUITABLE FOR INDOOR APPLICATIONS
* SEE MAX. RUN PER POWER FEED
BOOT END CAP
BOTTOM FEED
CONNECTOR
END FEED
CONNECTOR
A
B
C
POWER SUPPLY
CONTROL
24V DC
black wire: -
red wire: +
WIRING DIAGRAM
–
To minimise voltage drop and ensure consistent light
output, position the power supply near to the power feed
end of the LED Ribbon, and keep the line as short as
possible
–
Ensure your maximum run per power feed adheres to the
guidelines; 15m when using a single connector, or 30m
when using both connectors
–
Ensure to add 20% buffer when selecting a power supply
Mounting clips hold Encapsulated LED Ribbon in place and
allow for the creation of unique shapes and designs.
Quantity of mounting clips required depends on length of
product, desired shape and mounting surface angle.
Connectors and End Caps supplied in installation kits with cable, for single or double feed installations.
As with general LED ribbon, Encapsulated LED Ribbon requires the soldering of cable onto LED solder
pads, with the use of silicone connectors to ensure an IP65 protective seal.
0800 952 000 | www.brightlight.co.nz |
BRIGHT
LIGHT
14
13
8
14
20
8
6
14
8
16
8
MOUNTING CLIPS
IP65 CONNECTION ACCESSORIES
