Brightline Stealth-T, Operation And Installation Manual

4

1. Unpack the fixtures. The louver frames and lamps may be packed with the fixtures or separately. 

       To prevent damage, install the fixtures before installing lamps and louver frames.

2. Prepare the line-voltage wiring to the fixtures. Depending on building conditions, it may be necessary

       to install the power and control wiring before the fixture is placed in the ceiling. Ensure that the supply 

       voltage matches that required by the ballasts. To install the power feed, remove the knockouts as needed

       and install the correct type of power cabling and strain relief (not provided). Connect the wires from the 

       feed using wire nuts, observing the wire color-coding, and re-install the knockout plate. 

Brightline

       fixtures intended for the North American market use Black/White/Green wires respectively for 

       Line/Neutral/Earth Ground; fixtures shipped to other locations use Brown/Blue/Green-Yellow for 

       Line/Neutral/Earth Ground. You may want to install sufficient slack in the power cable so that, if

       necessary, the fixture can be moved to an adjacent ceiling opening.

 
3. These fixtures are not Insulated Ceiling (IC) rated. Maintain the proper distance from insulation 

       (3 in [76 mm] in the US and Canada).

4. If the fixture requires low-voltage control, the proper wiring must be run to each fixture.  Connect the 

      control wires inside the fixture, observing the proper color-coding. Install the control wiring 

      above the ceiling. (See the 

Control Wiring

 section below.)

5. Fixtures can be mounted in two ways: either flush-mount in a “hard” ceiling, such as plaster or drywall;

      or mounted in a T-Grid acoustical-tile ceiling.

Installation

Figure 3

Figure 1

Figure 2

•  

Hard Ceilings:

 Verify that the locations in which you 

   intend to mount the fixtures are free of above-ceiling

   obstructions such as ceiling joists, air conditioning

   ducts, etc. For ease of installation, a minimum of 

   8 in [203 mm] of clear height above the ceiling is

   recommended. In accordance with drawings provided 

   by 

Brightline

 or the local architect or engineer, prepare 

   the ceiling by cutting openings that are 24.56- x 24.56-in 

   [624- x 624-mm] in size. Depending on ceiling construction,

   it may be necessary to install a frame in the opening to 

   accommodate the weight of the fixture. Install the power and 

   control wiring as described above. With the mounting clips 

   in their recessed position (folded back next to the fixture, 

   see figure 1), lift the fixture into its opening. 

   Using a screwdriver, turn the screws on the bottom of the mounting clips until the clips turn approximately 

   90° and rest on the frame or ceiling structure. (Figure 2) Adjust the clips so the bottom of the fixture is 

   flush with the exposed side of the ceiling. (Figure 3)