7
Phase-Control (Two-Wire) Riser Diagram
Electrical installation:
Brightline provides a sealable power bracket with a
3-pole terminal block on its interior face and a
power inlet for cord up to 15mm. To wire the
fixture:
1. Untighten self-tapping screw
2. Remove bracket from fixture enough to
access terminal block
3. Feed leads through the grommetted hole
4. Wire according to label adjacent to
terminal block. Tighten contact screws
5. Re-insert bracket into fixture and close
with self-tapping screw
Summary of Contents for Stealth-T
Page 9: ...9 Page left blank intentionally ...
Page 14: ...14 Notes ...
